Element Description
Knob 5 (SEQUENCE) Selects a Sequence for the arpeggio. This parameter is shared with
MASCHINE controllers.
OTHER Section
Knob 6 (OCTAVES) Adjusts the Octaves parameter. This parameter is shared with
MASCHINE controllers.
Knob 7 (DYNAMIC) Adjusts the Dynamic parameter. This parameter is shared with
MASCHINE controllers.
Knob 8 (GATE) Adjusts the Gate parameter. This parameter is shared with
MASCHINE controllers.
As when your KOMPLETE KONTROL S-SERIES keyboard is connected to the KOM-
PLETE KONTROL software, the displays below the first four Knobs always show the pa-
rameter values — as opposed to other Knobs whose displays show the parameter name
by default and the parameter value when touched. This provides a quicker way of check-
ing important parameters in a live situation, since their values are quite self-explanatory.
To sum up, all Arp parameter values are always synchronized between your KOMPLETE KON-
TROL S-SERIES keyboard and the connected controller from the MASCHINE family. Again, all
these parameters are described in section Scale and Chord Parameters.
15.6 Using the Touch Strips
When your keyboard is focused on a MASCHINE instance, its left and right touch strips always
send Pitch and Modulation data to the focused Sound, respectively.
The way Pitch and Modulation data is interpreted can vary with the Plug-in loaded in the
focused Sound. For example, MASCHINE’s Sampler Plug-in lets you configure various
destinations for the Modulation data (in the MODWHEEL DESTINATION section of the
Velocity / Modwheel page, in the Control area).
KOMPLETE KONTROL Integration
Using the Touch Strips
MASCHINE - Manual - 854
To Next Page
Loading...
Need help?
General
