Parameter Description
Decay Adjusts the damping of the plate, which directly affects the
decay time of the reverb.
EQ Section
Low Shelf Controls the low-frequency content in the reverberated signal.
High Damp Adjusts the damping of the high frequencies in the reverberated
signal.
OUTPUT Section
Mix Mix lets you adjust the amount of the effect in relation to the
dry original audio signal.
The Plate Reverb on the controller.
12.5 Delays
12.5.1 Beat Delay
The Beat Delay is specialized for creating delays that are synced to the tempo. If you wonder
how this sounds, load up the Project “Big Stream” from the MASCHINE factory library: the
Beat Delay is used in various Groups here and offers a lot of rhythmic sonic possibilities.
Please note that in the Control area and on your controller the Beat Delay parameters are
spread over two pages.
Effect Reference
Delays
MASCHINE - Manual - 651
To Next Page
Loading...
