▪ Vintage: ↑10.3.6, Snare – Vintage
▪ Chrome: ↑10.3.7, Snare – Chrome
▪ Iron: ↑10.3.8, Snare – Iron
▪ Clap: ↑10.3.9, Snare – Clap
For more information on engines, see ↑10.1.1, Engines: Many Different Drums per
Drumsynth. For general information on the Snare and the other Drumsynths, see ↑10.1,
Drumsynths – General Handling.
10.3.1 Snare – Volt
The Volt engine is the default engine of the Snare.
The Volt snare is an electronic snare based on a family of analog classics.
The parameters described below are presented as they appear in the Control area (Ar-
range view). The same parameters are available in the Plug-in panel within the Plug-in
Strip (Mix view). See ↑9.4, The Plug-in Strip for more information on this.
Main Page
Element Description
MAIN Section
Engine Selects the engine used in the Snare Plug-in. If you change this
setting, please refer to ↑10.3, The Snares.
Tune Adjusts the pitch of the drum played by the middle C, measured in
MIDI note numbers and cents. Available values range from 53.00 to
77.00. The default value is 65.00. For more details see ↑10.1.5,
Pitch Range, Tuning, and MIDI Notes.
Decay Adjusts the duration of the sound’s tail, measured as a percentage.
Available values range from 0.0 to 100.0 % (default: 50.0 %).
Using the Drumsynths
The Snares
MASCHINE - Manual - 517
To Next Page
Loading...
Need help?
General
