Parameter Description
Filter Activates a filter on the side-chain input. This filter can be useful to
select only a specific frequency range of the side-chain signal to
control the Plug-in.
Center Freq Adjusts the center frequency of the filter.
Width Adjusts the bandwidth of the filter.
On your controller the outputs available in the SOURCE parameter are labeled as in the
display of the Source selector described above.
Note that the settings of the Side-Chain Input page stay in place when you switch to an-
other Plug-in supporting side-chain. This notably allows you to try different compressors
or different compression presets without losing the side-chain setup.
11.2 Applying Effects to External Audio
MASCHINE’s flexible routing facilities allow you to apply effects to external audio as well. This
external audio can come from the inputs of your audio interface if MASCHINE is used in
stand-alone mode, or from your host if MASCHINE is used as a plug-in.
To do this, we will choose a Sound and make use of the Audio page in its Input properties.
11.2.1 Step 1: Configure MASCHINE Audio Inputs
MASCHINE’s audio input configuration can be done in the software only. Furthermore, this
configuration is necessary only if you use MASCHINE as stand-alone application.
If you are using MASCHINE as a plug-in in a host application, MASCHINE can receive
audio from your host on any of its eight mono virtual inputs. To know how to route audio
in your host to the virtual inputs of the MASCHINE plug-in, please refer to your host
documentation. When this is done, go directly to section ↑11.2.2, Step 2: Set up a
Sound to Receive the External Input.
Using Effects
Applying Effects to External Audio
MASCHINE - Manual - 589
To Next Page
Loading...
Need help?
General
