Assigning the Macro Controls is possible in the software only.
Opening the Pages Pane in the Assignment Area
First of all, you need to open the Pages pane of the Assignment area for Macro properties. To
do this:
1. Select the Macro properties of the desired channel (Sound, Group, or Master) as descri-
bed in section ↑2.3.3, Navigating Channel Properties, Plug-ins, and Parameter Pages in
the Control Area.
2. Click the down-pointing arrow in the bottom left corner of the Control area to reveal the
Assignment area underneath:
3. Click the Pages tab in the left part of the Assignment area:
→
The Pages tab lights up and the Pages pane appears on its right. You are now ready to
assign Macro Controls to parameters.
Once the Assignment area is open, when you switch to other Parameter pages the As-
signment area follows your selection: it always shows the assignments for the page cur-
rently displayed above.
The Pages tab can be clicked only for Native Instruments or External Plug-ins and for
Macro properties. For all other Plug-ins and Channel properties, parameters and Param-
eter pages are not editable, and the Pages tab is grayed out and inactive. For more infor-
mation on how to assign parameters of Native Instruments or External Plug-ins to Pa-
rameter pages, please refer to ↑6.3.3, Setting Up Your Own Parameter Pages.
Audio Routing, Remote Control, and Macro Controls
Creating Custom Sets of Parameters with the Macro Controls
MASCHINE - Manual - 451
To Next Page
Loading...
Need help?
General
