The parameters described below are presented as they appear in the Control area (Ar-
range view). The same parameters are available in the Plug-in panel within the Plug-in
Strip (Mix view). See ↑9.4, The Plug-in Strip for more information on this.
Main Page
Element Description
MAIN Section
Engine Selects the engine used in the Kick Plug-in. If you change this
setting, please refer to ↑10.2, The Kicks.
Tune Adjusts the pitch of the drum played by the middle C, measured as
a percentage. Available values range from 0.0 to 100.0 % (default:
50.0 %). For more details see ↑10.1.5, Pitch Range, Tuning, and
MIDI Notes.
Decay Adjusts the duration of the sound’s tail, measured as a percentage.
Available values range from 0.0 to 100.0 % (default: 50.0 %).
Punch Simultaneously adjusts the amount of the pitch envelope and the
amount of noise of the attack. Available values range from 0.0 to
100.0 % (default).
Impact Adjusts how hard the drum is hit. Available values range from
0.0 % (softest) to 100.0 % (hardest). The default value is 75.0 %.
Advanced Page
For this engine the Advanced page does not contain any parameters.
Modulation Page
As with all other engines and Drumsynths, the Modulation page contains one parameter: Veloc-
ity.
Using the Drumsynths
The Kicks
MASCHINE - Manual - 514
To Next Page
Loading...
Need help?
General
