Element Description
SPECTRA Section
Mode Selects from two different noise types that simulate the wires of the
drum. Available modes are A (default) and B.
Tune Provides an independent tuning of the snare noise. It relates to the
tension of the snare wires on a real snare drum. Available values
range from 0.0 to 100.0% (default: 50.0%).
Decay Adjusts the length of the sound of the snare wires, independently
from the main Decay parameter on the Main page. Available values
range from 0.0% to 100.0% (default: 40.0%).
Amount Adjusts the amount of snare wire sound applied to the drum,
measured as a percentage. Available values range from 0.0 to
100.0% (default: 75.0%).
Modulation Page
Like with all other engines and Drumsynths, the Modulation page contains one parameter: Ve-
locity.
Element Description
SCALE Section
Velocity Adjusts the velocity response of the drum. Available values range
from -100.0% to 100.0% (default value). At zero (mid course), the
drum is played at full velocity, no matter how hard you hit the keys
(or pads). From that mid position, by turning the knob to the right
you increase the positive velocity response and make the drum more
sensitive to the velocity at which you hit the keys/pads. From the
mid position, turning the knob to the left as the inverse effect: the
harder you hit the key/pad, the softer the resulting drum sound will
be.
Using the Drumsynths
The Snares
MASCHINE - Manual - 535
To Next Page
Loading...
Need help?
General
