Parameter Description
Filter Activates a filter on the side-chain input. This filter can be useful to
select only a specific frequency range of the side-chain signal to
control the Plug-in.
Center Freq Adjusts the center frequency of the filter.
Width Adjusts the bandwidth of the filter.
On your controller the outputs available in the SOURCE parameter are labeled as in the
display of the Source selector described above.
For more information on how to use the side-chain input, please refer to section
↑11.1.3, Using the Side-Chain Input.
The Compressor on the controller: SIDE-CHAIN INPUT page.
Level Meters in the Compressor Panel (Plug-in Strip)
In the Plug-in Strip, the Compressor panel offers a few extra features not available in the Con-
trol area:
â–ª The Threshold and Gain faders (corresponding to the Threshold and Gain parameters of the
Main page in the Control area) provide level meters for visual monitoring of the input and
output levels. In particular, by comparing the input level with the position of the Threshold
fader, you can easily see you which parts of the signal will be compressed, and adjust the
Threshold fader accordingly.
â–ª An additional GR level meter indicates the gain reduction currently applied by the Compres-
sor to the input signal.
Effect Reference
Dynamics
MASCHINE - Manual - 610
To Next Page
Loading...
Need help?
General
