Element Description
Reverb Time Adjusts the reverb decay time. Turn clockwise to increase decay.
Available values range can be adjusted in seconds from 0.5s to
20.2s (default: 2.2s).
Reverb Size Adjust the size of the simulated room. Turn clockwise to increase
the perceived size of the room and reverb reflections. Available
values range from 0.0 to 100.0% (default: 10.0%).
COLOR Section
Damping Adjusts damping of the high frequencies in the reverb signal.
Damping refers to the rate at which the high frequencies decay.
This effect causes the sound to become gradually muffled and
warmer. Available values range from 0.0 to 100.0% (default:
50.0%).
Modulation Sets the modulation amount. A value of 0 turns the delay
modulation off. Available values range from 0.0 to 100.0%
(default: 40.0%).
Softness Alters the balance between early reflections and the late reverb tail.
It also changes the amount of diffusion present. It allows you to
soften the attack of the reverb and push it more into the
background, so it doesn't muddy the dry sound so much. Available
values range from 0.0 to 100.0% (default: 90.0%).
Pre Delays Adjusts the initial delay between the original signal and the first
reverberant sound. At higher values this can also be used in many
creative ways. Available values can be adjusted in milliseconds from
0.0ms to 250.0ms (default: 0.0ms).
OUTPUT Section
Mix Adjusts the ratio between the effect (wet) signal and original (dry)
signals. Available values range from 0.0 to 100.0% (default:
50.0%).
Effect Reference
Spatial and Reverb Effects
MASCHINE - Manual - 649
To Next Page
Loading...
Need help?
General
