The Saturator in Tape mode in the Control area.
Tape Mode – Parameter Description
MAIN Section
Mode Selects between Classic, Tape, and Tube saturation modes. All
other parameters vary according to the mode selected here.
Input Controls the input gain of the effect. This affects the amount of
tape distortion and compression.
Contour Controls the high frequency roll-off starting frequency.
Frequencies above this point will be attenuated.
Drive Controls the low frequency boost/cut of the effect.
Tube Mode
The Tube mode emulates the smooth saturation of overdriven tube amplifiers. It is equipped
with a feedback-driven dynamic compression and an additional EQ section allowing you to fine
adjust the frequency content to be processed.
The Saturator in Tube mode in the Control area.
Effect Reference
Distortion Effects
MASCHINE - Manual - 665
To Next Page
Loading...
