Provides a set of destructive audio processing functions to modify your Sample. The functions
will be applied to the current selection range. The available functions are described in section
↑14.3.2, Audio Editing Functions below.
You can also edit the play and loop ranges on the Zone page. See section ↑14.5.6, Ad-
justing the Zone Settings for more information.
Using the EDIT Page on Your Controller
â–º
In Sampling mode, press Button 2 to access the EDIT page.
The EDIT page on the controller.
The right display shows the waveform of the selected Sample:
â–ª Turn Knob 5 to zoom in on the waveform of the Sample and Knob 6 to scroll through it.
â–ª Above the waveform, the information bar indicates the name and length of the Sample.
â–ª The Sample can be played back at any time by pressing the corresponding pad on your
controller. When the Sample is played back, the playhead indicator (vertical line) shows
you the current play position within the waveform on the right display.
The parameters available at the bottom of the left display are spread over two pages.
â–º
Use the Page buttons on the left of the displays to select the desired page.
Page 1 – PLAY RANGE Parameters
The parameters in the PLAY RANGE section allow you to adjust the range that will be played
back when you trigger a note.
Sampling and Sample Mapping
Editing a Sample
MASCHINE - Manual - 771
To Next Page
Loading...
Need help?
General
