Parameter Description
SRC BPM (Source
BPM, Beat mode
only)
Allows to define the tempo of the original audio (in BPM). This tempo
is defined in different ways according to the AUTO DTCT value:
If AUTO DTCT is enabled, you can set the length (in bars) of the
original audio. You can choose between 1/2, 1, and 2 bars. The
number between brackets indicates the resulting tempo (in BPM)
derived from the number of bars you have set and the computed
tempo value.
If AUTO DTCT is disabled, you can directly define the tempo of the
original audio (in BPM).
NEW BPM
(Beat Mode only)
Defines the target tempo of the time-shifted audio (in BPM).
LENGTH (Stretch
Length, Beat mode
with Auto Detection
enabled only)
If AUTO DTCT is enabled, you can define the length of the target
audio (in bars). Please note that any change to the SRC BPM value
(see above) will be automatically mirrored by this LENGTH value. Once
you have set the number of bars in the source audio, you can set here
another number of bars, thereby dividing or multiplying the tempo of
the target audio. Available values are 1/16, 1/8, 1/4, 1/2, 1, 2, 4, and
8 bars, as well as the corresponding triplet values.
SPEED
(Free mode only)
Adjusts the new tempo relative to the original tempo (in percentage).
The minimum value is 10 %.
In Beat mode, if you set a target tempo that is smaller than a tenth of the original tem-
po, the Apply button will be disabled. Set a higher target tempo to enable the Apply but-
ton again!
â–º
Once you have set the parameters to the desired values, click Apply to apply the pitch
shifting and/or time stretching to the selected region in the Sample, or Cancel to let the
Sample untouched.
Sampling and Sample Mapping
Editing a Sample
MASCHINE - Manual - 776
To Next Page
Loading...
Need help?
General
