Parameter Description
FADE OUT This applies a fade out to the selected region of the Sample.
FIX DC This removes the DC offset. DC offset (“Direct Current offset”) is an
undesirable constant shift in the signal level that might be
introduced by some audio processing units. This offset can notably
waste some of the available headroom.
SILENCE This silences the selected region of the Sample.
CUT This deletes the selected region from the Sample and places it into
the clipboard for later use.
COPY This copies the selected region of the Sample to the clipboard for
later use.
PASTE This pastes the cut/copied region of the Sample, replacing the region
of the Sample currently selected.
DUPLICATE This duplicates the selected region of the Sample. The copy is
placed right after the original region.
STRETCH This allows you to apply time stretching and/or pitch shifting to the
selected region of the Sample. See below for a detailed description.
Time Stretching / Pitch Shifting
When STRETCH is selected, pressing Button 7 (SETTINGS) allows you to adjust the parame-
ters of the time stretching / pitch shifting function before applying it to the selected region.
Use Knob 1–8 to adjust the parameters. Pitch shifting and time stretching can be applied in-
dependently.
Parameters for the Stretch function.
Following parameters are available via Knob 1–8:
Sampling and Sample Mapping
Editing a Sample
MASCHINE - Manual - 778
To Next Page
Loading...
Need help?
General
