Native Instruments Maschine User Manual

With SLICE or REMOVE enabled, you can still prelisten to your individual Slices by
pressing the corresponding pads on your controller!
Manually Adjusting Slices Using Your Controller
Your controller provides a dedicated Slice Edit mode that allows you to select and fine-tune
each particular Slice.
►
On the SLICE page of the Sampling mode, press Button 5 (EDIT) to enter/leave Slice Edit
mode.
→
When Slice Edit mode is active, Button 5 is fully lit and the EDIT label underneath is
highlighted.
The Edit mode in the SLICE page.
In Slice Edit mode following parameters and commands are available:
Parameter
Description
SELECTION section
SLICE (Knob 1) Selects the Slice to edit. The display will show you which Slice is
currently selected. You can also use the pads to select Slices starting
from pad 1.
START (Knob 3) Adjusts the start point of the selected Slice. Hold SHIFT when
turning the Knob to adjust the parameter in finer increments. If the
start point of the Slice and the end point of the previous Slice are
still joined, moving the start point of the Slice simultaneously moves
the end point of the previous Slice, so that both Slices stay joined.
Sampling and Sample Mapping
Slicing a Sample
MASCHINE - Manual - 793

Native Instruments Maschine Specifications

General

Weight	4.85 lbs (2.2 kg)
Pads	16 velocity-sensitive pads with aftertouch
Connectivity	USB, MIDI In/Out
Software	Maschine Software
Compatibility	Mac and PC
Power Supply	USB powered
Audio Interface	No built-in audio interface
Sequencer	Yes, pattern-based sequencer
Sampling	Yes, integrated sampler
Effects	Yes, includes a variety of effects
Encoders	8 knobs with LED ring indicators
DAW Integration	Yes, works as a plugin within most major DAWs