200
FRAME LOSS Tab
• Max Rate – Defines the rate so that the frame loss test should begin with, in
terms of a percentage of line rate or in Mbps.
• Step Size – Defines frame loss test step size. The step size is based on line rate
(% or Mbps).
• Test duration – Defines the duration (sec) to run each iterative test.
• Thresholds – Defines the threshold value in percentage of frame loss. If
determined frame loss value for specific frame size is greater that the
threshold value the test is declared as FAIL.
BURST (Back to Back) Tab
• Max Rate – Defines burst test transmission rate in terms of a percentage of line
rate or Mbps.
• Accuracy – Defines the number of frames to reduce in the burst for the next
iteration if the previous burst size fails.
• Repetitions – Defines the number of times to run each iterative test.
• Max Duration – Defines the duration (sec) to run each iterative test.
• Threshold – Defines the threshold value in percentage of maximum burst
length. If determined burst length value for specific frame size is lower than
threshold value the test is declared as FAIL.
• Use binary search – If enabled, the next transmission rate is one half of the
difference between the previous successful rate and the previous failed rate.
To Next Page
Loading...