216
12.8.5 Ethernet - HTTP
HTTP is used to test and benchmark the performance of web applications, web servers. The HTTP test allow the
NetProbe to measure the time required to download a web page.
To run HTTP, follow the steps below:
1. Select a url or IP address for the test from the drop down or click in the Address
entry block and enter an FTP address.
2. Press the Start button, observe the progress bar. Success is indicated by a green
check and a failure is indicated by the red bar.
When the test completes successively, the following measurements are displayed.
• Throughput (Current, Average)
• Data transfer rate
• Transfer Time
To Next Page
Loading...