346
21.10 Gigabit Basic Analzer Option:
Electrical Gigabit Interface:
10/100/1000Base-T, RJ-45
Optical Gigabit Interface:
SFP Duplex LC, field removable
Optical Power Measurement - Tx and Rx
SFP device ID and status
NP2000-ETH-BsSx
1000Base-SX
Transmitter
– Wavelength: 850 nm multi-mode
– Power: -9.5 dBm to -4 dBm
Receiver
– Wavelength: 770 nm to 860 nm
– Signal: -21 dBm to 0 dBm max
NP2000-ETH-BsLx
1000Base-LX
Transmitter
– Wavelength: 1310 nm single-mode
– Power: -9.5 dBm to -4 dBm
Receiver
– Wavelength: 1270 nm to 1600 nm
– Signal: -25.5 dBm to -3 dBm max
NP2000-ETH-BsZx
SA580-1550 (1000Base-ZX)
Transmitter
– Wavelength: 1550 nm single-mode
– Power: +3 dBm to -2 dBm
Receiver
– Wavelength: 1270 nm to 1570 nm
– Signal: -24 dBm to -3 dBm max
Wiremap:
Open, short, crosstalk, length, impedance
Loopback:
Manual, Layer 1,2,3
BERT:
Single-ended test with loopback on the remote end
End-to-end testing with two sets
Layers: 1 ,2, 3, 4
Test Patterns: All 0’s, All 1’s, 1:1, 1:3, 2:2, 5:32, 2
15
-1, 2
20
-1, 2
23
-1, 2
31
-
1, user defined
Frame size: 64-9600B
Error Injection: Code, Bit, CRC, Single, Rate 10
-1
to 10
-8
Measurements:
start time, test duration,
Tx and Rx Line rate, Frame Cout, Bits Count, Bytes Count,
Tx and Rx Data Rates Current, Min, Max , Average, Tx and Rx
Frame/sec Current, Min, Max Average
Rx Errors Current and Total ( Bit, BER, Code Rate, CRC, CRC Rate,
Collisions, Histograms of any)
Alarms LOS, Link Down/time, Sync/time
Service Disruption (last, Min, Max, Average, Total, Times)
Delay, Jitter
RFC 2544 Compliance:
Layers: 1,2,3,4
Frames size: 64,128,256,512,1024,1518 bytes or user definied
Throughout
Latency + Jitter
To Next Page
Loading...