241
Performance Test Results
Click on this tab to display the Performance test
results:
• Rx ULR (Rx Utilization Rate)
• FTD (Frame Transfer Delay)
• FDV (Frame Delay Variation)
• Tx ULR
• FLR (Frame Loss Rate)
• Availability
• Unavailability seconds
Parameters that are verified against Service Acceptance Criteria (defined on SAC tab) are display with a yellow
backlight. The Service Performance test pass if all verified parameters are found to be within acceptable limits. If
any parameter exceeds limit, it becomes highlighted in red and test verdict is reported as FAIL.
To Next Page
Loading...