NetComm NL1901ACV - Firmware and Reboot Management

NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
123 of 146
UG01063 v. 1.0 December 2018
© NetComm Wireless 2018
Management – Update Firmware
The following screen appears when selecting the Update Firmware option from the Management menu. By
following this screen’s steps, you can update your gateway’s firmware. Manual device upgrades from a locally
stored file can also be performed using the following screen.
1 Obtain an updated software image file from:
http://support.netcommwireless.com/
2 Click the
Choose File button to locate the image file.
3 Click the
Update Firmware button once to upload and install the file.
Figure 136 – Update Firmware page
Management – Reboot
This option reboots the NL1901ACV. Please allow up to 5 minutes for device to reboot.
Figure 137 – Reboot button
Note 1.
– It may be necessary to reconfigure your TCP/IP settings to adjust for the new configuration. For example, if you disable the
Dynamic Host Configuration Protocol (DHCP) server you will need to apply Static IP settings to your Network interface card (NIC).
Note 2.
– If you lose all access to your web user interface, simply press and hold the reset button on the rear panel for 10 seconds to
restore default settings