NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
UG01063 v. 1.0 December 2018
WAN Service
The WAN Service page displays the current Wide Area Network service setup and allows you to configure the
gateway to connect to a larger network for Internet access.
– WAN service requires a preconfigured Layer 2 interface, be it ATM/PTM or Ethernet WAN.
Figure 39 – NL1901ACV gateway
To add a WAN service, click the Add button.
Use the drop down list to select the layer 2 interface to use for the WAN service and click the
Next button.
Figure 40 – WAN Service – Select layer 2 interface
Select a WAN service type, enter a Service Description, enter the 802.1P Priority and 802.1Q VLAN ID if required,
then click the
Next button.
To disable VLAN tagging, place input value of -1. Refer to your ISP for VLAN information as required by your
Internet Service Provider.
To Next Page
Loading...
