NetComm NL1901ACV - Table 33 - Ipsec Settings Table

NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
82 of 146
UG01063 v. 1.0 December 2018
© NetComm Wireless 2018
PARAMETER
DEFINITION
IPSec Connection Name
Enter a name to identify the IPSec tunnel.
Tunnel Mode
Select the applicable IPSec tunnel mode.
Remote IPSec Gateway
Enter the IP Address of the IPSec server to connect to.
Tunnel access from Local
Select which remote addresses local IPSec connections are
able to access .
IP Address from VPN
Enter the IP Address to be used locally for the IPSec tunnel.
Subnet mask for VPN
Enter the subnet mask to be used locally for the IPSec tunnel.
Tunnel Access from
Remote
Select which local addresses remote IPSec connections are
able to access.
IP Address for VPN
Enter the IP Address to be used on the remote end for the
IPSec tunnel.
Subnet mask for VPN
Enter the subnet mask to be used on the remote end for the
IPSec tunnel.
Key Exchange Method
Select the type of IPSec exchange is to be used on the IPSec
tunnel.
Authentication Method
Select the applicable authentication for the IPSec tunnel.
Pre-Shared Key
Enter the pre-shared key (if applicable) to grant access to the
IPSec tunnel.
Perfect Forward Secrecy
Select to use Perfect Forward Secrecy during key exchange
for the IPSec tunnel.
Advanced IKE Settings
Configure advanced IKE settings for the IPSec tunnel such as
the encryption method or key life time.
Table 33 – IPsec settings table