NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
UG01063 v. 1.0 December 2018
21 To test your Quality of Service settings try running speed-tests (http://speedtest.net) on both PCs/devices
simultaneously.
Limiting the upstream rate
1 By default, a QoS queue is created when a WAN interface is created but it is disabled by default. On the
QoS Queue page, enable the queue for the appropriate WAN interface.
Figure 150 – QoS Queue details
2 On the QoS Classification page, add a rule to limit the upstream rate, for example:
Classification Criteria:
Class Interface: LAN
Ether type: IP
Classification Results:
Class Queue: the queue that was enabled in Step 1
Set rate-limit: set according to your preference
Figure 151 – Network Traffic Class Rule
3 Click Apply/Save.
To Next Page
Loading...
