NetComm NL1901ACV - WAN Configuration Details

NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
35 of 146
UG01063 v. 1.0 December 2018
© NetComm Wireless 2018
WAN
The WAN page shows more detailed information related to the WAN interface configuration, including the firewall
status, IPv4 and IPv6 addresses of the gateway.
Figure 25 – NL1901ACV gateway – WAN Info list
ITEM
DEFINITION
Interface
The Interface of the WAN connection.
Description
The description of the WAN connection.
Type
The type of WAN connection.
VLAN Mux ID
Details the status of VLAN Mux ID, if used.
IPv6
The status of IPv6.
IGMP Pxy
Details the status of IGMP (Internet Group Management Protocol) traffic
on each WAN connection. IGMP is only used with IPv4 connections.
IGMP proxy enables the gateway to issue IGMP host messages on behalf
of hosts that the gateway discovered through standard IGMP interfaces,
allowing NAT transversal of Multicast traffic.
IGMP Source
Enable
Details the status of IGMP source on each WAN connection. IGMP
Sources function send a membership report that includes a list of IGMP
source addresses.
MLD Pxy
Shows the status of the Multicast Listener Discovery protocol when IPv6 is
in use.
Multicast Listener Discovery (MLD) proxy enables the gateway to issue
MLD host messages on behalf of hosts that the gateway discovered
through standard MLD interfaces.
MLD Source
Enable
Details the status of MLD source on each WAN connection.
MLD Sources function can send a membership report that includes a list
of MLD source addresses.
NAT
The NAT (Network Address Translation) status of the WAN connection:
Enabled
or
Disabled
Firewall
The status of the gateway firewall across the WAN connection.
Status
The status of the WAN connection:
Connected
,
Unconfigured
, etc.
IPv4 Address
The current IPv4 address of the WAN interface.
IPv6 Address
The current IPv6 address of the WAN interface.
Table 11 – WAN Info table