NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
UG01063 v. 1.0 December 2018
Hardware installation
1 Connect the power adapter to the Power socket on the back of the NL1901ACV.
2 Plug the power adapter into the wall socket and switch on the power.
3 Wait approximately 60 seconds for the NL1901ACV to power up.
Connecting a client via Ethernet cable
1 Connect the yellow Ethernet cable provided to one of the yellow ports marked ‘Ethernet’ at the back of the
NL1901ACV.
2 Connect the other end of the yellow Ethernet cable to your computer.
3 Wait approximately 30 seconds for the connection to establish.
4 Open your Web browser, and enter http://192.168.20.1 into the address bar and press enter.
5 Follow the steps to set up your NL1901ACV.
Connecting a client wirelessly
1 Ensure WiFi is enabled on your device (e.g. computer/laptop/smartphone).
2 Scan for wireless networks in your area and connect to the network name that matches the Wireless network
name configured on the NL1901ACV.
– Refer to the included Wireless Security Card for the default SSID and wireless security key of your NL1901ACV.
3 When prompted for your wireless security settings, enter the Wireless security key configured on the
NL1901ACV.
4 Wait approximately 30 seconds for the connection to establish.
5 Open your Web browser, and enter http://192.168.20.1 into the address bar and press Enter.
6 Follow the steps to set up your NL1901ACV.
To Next Page
Loading...
