NetComm NL1901ACV - LAN Settings; IPv4 Autoconfiguration

NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
51 of 146
UG01063 v. 1.0 December 2018
© NetComm Wireless 2018
LAN
IPv4 Autoconfig
The LAN window allows you to modify the settings for your local area network (LAN).
Figure 49 – LAN setup -- IPv4 Autoconfig settings
The following options are available to configure:
PARAMETER
DEFINITION
IP Address
Enter the Local IP Address to use for the NL1901ACV.
Subnet Mask
Enter the subnet mask to define the subnet of the Local
Network.
Enable IGMP Snooping
Enable IGMP Snooping and select the IGMP Snooping mode
to use. Standard: allow all multicast traffic to LAN clients.
Blocking: only allow multicast subscribed clients to receive
multicast packets.
Enable LAN side Firewall
Enable the LAN side firewall to restrict traffic between LAN
host-LAN hosts and WiFi Clients.
Enable DHCP Server
Select to enable or disable the DHCP server and enter the
start and end address for the DHCP IP Address pool.