NetComm NL1901ACV - Low Priority QoS Classification

NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
134 of 146
UG01063 v. 1.0 December 2018
© NetComm Wireless 2018
12 Enter a Destination MAC Mask if you have entered a Destination MAC address and Destination IP address at
steps 10 and 11 above. This would normally be
255.255.255.0 unless your system administrator advises
otherwise.
If you have not entered a
Destination MAC or IP address, see steps 10 and 11 above, leave the field blank.
13 Set the
Differentiated Service Code Point (DSCP) Check to: EF(101110)
14 Set the
Protocol to TCP. Other options include: UDP, ICMP, IGMP
15 Set “
Assign Classification Queue” to Priority 1 (in the example above pppoa0&atm0&Path0&Key38&Pre1).
Other options or priority 2 and 3. Priority 1 gives the highest priority with priority 3 being the lowest.
16 Set
Mark Differentiated Service Code Point (DSCP) as: EF(101110)
17 Set
Mark 802.1p Priority as 5. In the scale 0-7, 0 is best effort, 6 and 7 are reserved for networking
performance so set 5 as the highest priority.
18 Enter the
Set Rate Limit in Kilobits Per Second (kbps).
19 Click the
Apply/Save button.
Low Priority QoS Classification
1 Select Advanced Setup > Quality of Service > QoS Classification.
2 Click the
Add button.
Figure 148 – QoS Network Low Priority Traffic Class Rule configuration