NetComm NL1901ACV - DSL Advanced Settings

NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
75 of 146
UG01063 v. 1.0 December 2018
© NetComm Wireless 2018
DSL Advanced settings
For advanced DSL options press the Advanced Settings button.
The DSL advanced settings relate to test mode settings. The default selection is
Normal.
Figure 87 – DSL Advanced Settings page
FIELD
DESCRIPTION
Normal
Puts the gateway in normal operation mode. The default setting.
Reverb
Puts the gateway in a test mode in which it only sends a Reverb signal.
Medley
Puts the gateway in a test mode in which it only sends a Medley signal.
No retrain
In this mode, the gateway will try to establish a connection as in normal
mode, but once the connection is up it will not retrain if the signal is lost.
L3
Puts the gateway in the Link state (Idle) at the start of the initialization
procedure.
Apply button
Click the
Apply
button to initiate the change.
Tone Selection
button
Allow selection of frequency band for data transfer.
Table 32 – DSL settings table