NetComm NL1901ACV - Additional Product Information; Establishing a Wireless Connection

NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
125 of 146
UG01063 v. 1.0 December 2018
© NetComm Wireless 2018
Additional Product Information
Establishing a wireless connection
Windows 7
1 Open the Network and Sharing Center (Start > Control Panel > Network and Sharing center).
2 Click on "
Change Adapter settings" on the left-hand side.
3 Right-click on "
Wireless Network Connection" and select "Connect / Disconnect".
4 Select the wireless network listed on your included wireless security card and click
Connect.
5 Enter the network key (refer to the included wireless security card for the default wireless network key).
6 You may then see a window that asks you to "Select a location for the 'wireless' network". Please select the
"
Home" location.
7 You may then see a window prompting you to setup a "
HomeGroup". Click "Cancel" on this.
8 You can verify your wireless connection by clicking the "
Wireless Signal" indicator in your system tray.
9 After clicking on this, you should see an entry matching the SSID of your NL1901ACV with "
Connected" next
to it.
Windows 8/8.1/10
1 Open the Network and Sharing Centre (Click on Start, type “Network and Sharing Centre”)
2 Click on “
Change adapter settings” on the left hand column.
3 Right-click on
Wireless Network Adaptor and select "Connect / Disconnect".
4 Select the wireless network listed on your included wireless security card and click
Connect.
5 Enter the network key (refer to the included wireless security card for the default wireless network key).
6 You can verify your wireless connection by clicking the "
Wireless Signal" indicator in your system tray.
7 After clicking on this, you should see an entry matching the SSID of your NL1901ACV with "
Connected"
under it.
Mac OSX 10.6
1 Click on the Airport icon on the top right menu.
2 Select the wireless network listed on your included wireless security card and click
Connect.
3 On the new window, select “
Show Password”, type in the network key (refer to the included wireless security
card
for the default wireless network key) in the Password field and then click on OK.
4 To check the connection, click on the
Airport icon and there should be a  tick on the wireless network
name.
Note
– For other operating systems, or if you use a wireless adaptor utility to configure your wireless connection, please consult the
operating system documentation for instructions on establishing a wireless connection.