NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
UG01063 v. 1.0 December 2018
f Click the
Finish button when you have entered the required details.
The account settings are saved and the NL1901ACV connects to the internet.
Ethernet WAN
Select Ethernet WAN if you connect to the internet via an upstream gateway device such as an FTTP gateway or
HFC cable gateway.
Figure 14 – NL1901ACV gateway – Ethernet WAN connection setup
– The
card pictured above is optional. It can be deployed as the primary data connection or, more commonly, as a fallback
protection in case the primary data connection fails.
Refer to the
section on page 30.
a Connect an RJ45 Ethernet cable to the WAN port on the NL1901ACV. Connect the other end of the
cable to your WAN service.
b Select
Ethernet WAN then click the Next button.
Figure 15 – NL1901ACV gateway – Select Ethernet WAN as WAN connection type
To Next Page
Loading...
