NetComm NL1901ACV - Add;Edit Mobile Broadband Setup; Table 16 - USB Mobile Configuration Settings Table

NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
48 of 146
UG01063 v. 1.0 December 2018
© NetComm Wireless 2018
FIELD
DESCRIPTION
IGMP
Internet Group Management Protocol (IGMP) is used by hosts and
adjacent routers on IPv4 networks to establish multicast group
memberships.
NAT
NAT (Network Address Translation)
status of the mobile WAN
connection:
Enabled
or
Disabled
Firewall
The status of the gateway firewall across the mobile WAN
connection.
IPv6
If
IPv6
is available it can be
Enabled
, otherwise it will be
Disabled
.
MLD
Multicast Listener Discovery
(
MLD
) is used by IPv6 routers for
discovering multicast listeners.
Manage PIN
button
Click to open the
PIN settings
page where you can enable, disable
and change the PIN on the SIM.
Edit
setup details
button
Click open the
Mobile Broadband Setup
page to edit the details of
the current Mobile Broadband connection.
Action:
Connect/Disconnect
button
Click the
Connect
button to manually connect to the Mobile
broadband interface.
When connected this button changes to
Disconnect
and allows the
user to manually disconnect.
Add
button
Click open the
Mobile Broadband Setup
page, see next section.
Remove
setup button
You can only have one
Mobile Broadband
at a time.
To add a replacement setup click
Remove
and then click
Add
.
Information
button
Click to see details of the mobile broadband connection.
Table 16 – USB Mobile configuration settings table
Add/Edit Mobile Broadband Setup
Only one mobile cellular service can be defined at one time.
If one is not currently defined, click the
Add button.
If one already exists, either click the
Edit button or click the Remove button and then click the Add button.
Both the
Add and the Edit buttons open the Mobile Broadband setup dialog.