NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
UG01063 v. 1.0 December 2018
Advanced Setup
While you can set up your gateway directly from the Advanced Setup pages, we recommend that you use the First-
time Setup Wizard contained in the
Basic Setup section, see above.
Layer 2 Interface
ATM Interface
The ATM (Asynchronous Transfer Mode) interface page shows the settings of all available DSL ATM interfaces.
ATM interface is used for ADSL connections.
Figure 34 – DSL ATM Interface list
This field shows the interface name.
This field shows the Virtual Path Identifier (VPI) value.
For most Australian connections the VPI is 8, for most New Zealand
connections the VPI is 0.
Refer to your ISP for the correct value.
This field shows the Virtual Channel Identifier (VCI) value.
For most Australian connections the VCI is 35, for most New
Zealand connections the VCI is 100.
Refer to your ISP for the correct value.
The value of the DSL Latency.
This field shows the ATM service classes.
The maximum number of cells that may be transferred per second
over the ATM interface.
Sustainable Cell Rate
(cell/s)
An average, long-term cell transfer rate on the ATM interface.
The maximum allowable burst size of cells that can be transmitted
contiguously on the ATM interface.
The minimum allowable rate at which cells may be transferred on
the ATM interface.
This field shows the type of link in use.
This field shows the selected mode of connection.
This field shows the status of the Quality of Service (QoS) function.
To Next Page
Loading...
