NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
UG01063 v. 1.0 December 2018
DSL
This page allows you to modify the DSL modulation settings on the unit. By changing the settings, you can specify
which DSL modulation that the gateway will use.
Not all modulation types are support by your local DSLAM equipment, check with your ISP for supported
modulation types.
Figure 86 – DSL settings page
A user defined name for the policy route.
The LAN port to be used for the policy.
The IP address of the LAN device involved with the policy.
Select the Interface that the policy will employ.
Enter the gateway address.
button
Click the
button to initiate the change.
button
Allow configuration of the Gateway state for diagnostic
purposes.
Table 31 – DSL settings table
To Next Page
Loading...
