NetComm NL1901ACV - Cellular Network Status

NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
34 of 146
UG01063 v. 1.0 December 2018
© NetComm Wireless 2018
Cellular Network Connection Status
If you have enabled a SIM and are using it either as your primary data source via a Mobile Network broadband
service or as a fallback connection providing redundancy should your primary ADSL/VDSL/Ethernet WAN be
interrupted, this table will show the device status when this LTE service is being used.
Figure 24 – NL1901ACV gateway – Cellular Network connection status section
ITEM
DEFINITION
Network
The network operator that supplies the cellular service.
Network selection mode
Can be set exclusively for
3G
or
LTE (4G)
, or
Auto
which selects
4G first and then 3G if 4G not available.
APN
The
Access Provider Name
used by network operator.
Link
The current status of the cellular connection:
Connected
,
Not
connected
, etc.
Service Type
Type of mobile connection established: 3G or LTE
Signal Strength
Five levels of signal strength appear in the bar icons.
If all bars are empty, no signal is detected or there is no
connection.
The bars will fill with colour progressively from the left as the
signal strength improves.
Note
– If an enabled SIM is inserted, signal strength will be detected, measured
and indicated regardless of whether a connection to a network operator exists
or not.
SIM info
Indicates whether a valid SIM card is inserted into the SIM
socket or not.
Note
– Unit must first be turned off before inserting SIM card for it to be
detected on startup.
Connection Up Time
The time (in days, hours, minutes and seconds) since the cellular
connection was last established.
Table 10 – Cellular Network connection details table