NetComm NL1901ACV - Figure 48 - Mobile Broadband Setup Interface; Table 17 - DSL ATM Interface Configuration Settings Table

NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
49 of 146
UG01063 v. 1.0 December 2018
© NetComm Wireless 2018
Figure 47 – Mobile Broadband setup interface
FIELD
DESCRIPTION
Enable NAT

Enable NAT (Network Address Translation)
is a common
routing feature which allows multiple LAN devices to appear as
a single WAN IP via network address translation. In this mode,
the router modifies network traffic sent and received to inform
remote computers on the internet that packets originating from
a machine behind the router originated from the WAN IP
address of the router’s internal NAT IP address. This may be
disabled if a framed route configuration is required and local
devices require WAN IP addresses
User Name
The Username for your broadband service provided by your
broadband ISP.
Password
The
Password
for your broadband service provided by your
broadband ISP.
Authentication method
Choose:
AUTO
,
PAP, CHAP or MSCHAP
APN
Enter the
APN
(
Access Point Name
) provided by your
broadband ISP.
Dial Number
Enter the number to dial to get data connectivity provided by
your broadband ISP.
Net Select
Select the service your ISP provides,
3G
or
LTE
or allow the
router to auto-detect using
AUTO
.
Dial Delay (in secs.)
Enter the time delay in seconds that must elapse before re-
connecting to the mobile connection when primary connection
dropped, and mobile broadband is configured as backup.
Default WAN Connection
Select
Select either
Mobile Broadband
or
DSL OR ETHERNET.
WAN backup mechanism
DSL
IP connectivity
Apply/Save
button
Click to save and apply your changes.
Table 17 – DSL ATM Interface Configuration settings table
Note
– Mobile Broadband service requires an unlocked SIM card in the 2FF format. See
PIN settings
section on the next page.