NetComm NL1901ACV - Page 135

NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
135 of 146
UG01063 v. 1.0 December 2018
© NetComm Wireless 2018
3 Enter a Traffic Class Name indicating that it is a low-priority QoS rule, for example: PC2LowPriority
4 Leave the
Rule Order as Last.
5 Set the
Rule Status to Enable.
6 Set the Class Interface according to how the device connects to the gateway. In the example above
LAN is
selected. Other options are:
Wireless, Local, eth0, eth1, eth2, eth3, eth4.1(routed), wl0/5G or wl1/2.4G
7 Set the
Ether Type to IP(0x800).
Other options include:
ARP(0x8086), Ipv6(0x86DD), PPPoE_DISC(0x8863), 8865(0x8865), 8866(0x8866),
8021Q(0x8100)
8 Enter the
Source MAC Address of the device, the unique 12 character signature with every 2 characters
separated by a colon(:), that you previously entered to reserve the device's IP address.
9 Enter the Source IP Address of the device that you previously entered into the Static IP Lease List, in the
range of 192.168.1.x. In the example above the IP address is:
192.168.20.3
10 Enter a
Destination MAC Address if the connection is to a single device. This is useful for VPN connections.
If you wish the destination MAC address to be any address leave the field blank.
11 Enter a
Destination IP Address if the connection is to a single device. This is useful for VPN connections.
If you wish the destination IP address to be any address leave the field blank.
12 Enter a
Destination Subnet Mask if you have entered a Destination MAC address and Destination IP address.
This would normally be
255.255.255.0 unless your system administrator advises otherwise.
If you have not entered a
Destination MAC or IP address, see steps 10 and 11 above, leave the field blank.
13 Set the
Differentiated Service Code Point (DSCP) Check to AF11(001010).
14 Set the
Protocol to TCP. Other options include UDP, ICMP or IGMP.
15 Set “
Assign Classification Queue” to Priority 3 (in the example above pppoa0&atm0&Path0&Key39&Pre3).
Other options are priority 1 and 2. Priority 1 gives the highest priority with priority 3 being the lowest.
16 Set Mark Differentiated Service Code Point (DSCP) as: AF11(001010)
17 Set
Mark 802.1p Priority as 0. In the scale 0-7, 0 is best effort, 6 and 7 are reserved for networking
performance so set 0 as the lowest priority.
18 Enter the Set Rate Limit in Kilobits Per Second (kbps).
19 Click the
Apply/Save button.
You now have 2 Quality of Service rules implemented for 2 devices connecting to the NL1901ACV gateway.
Figure 149 – QoS Classification setup page
20 Select Management > Reboot. Click the Reboot button to restart the gateway and save the new settings.