NetComm NL1901ACV - Page 133

NL1901ACV Enhanced Hybrid 4G LTE Gateway – User Guide
133 of 146
UG01063 v. 1.0 December 2018
© NetComm Wireless 2018
Figure 147 – QoS Network High Priority Traffic Class Rule configuration
3 Enter a
Traffic Class Name indicating that it is a high-priority QoS rule, for example: PC1HighPriority
4 Leave the
Rule Order as Last.
5 Set the
Rule Status to Enable.
6 Set the
Ingress Interface according to how the device connects to the gateway. In the example above, LAN
is selected. Other options are:
Wireless, Local, eth0, eth1, eth2, eth3, eth4.1(routed), wl0/5G or wl1/2.4G
7 Set the
Ether Type to IP(0x800).
Other options include:
ARP(0x8086), Ipv6(0x86DD), PPPoE_DISC(0x8863), 8865(0x8865), 8866(0x8866),
8021Q(0x8100)
8 Enter the
Source MAC Address of the device, the unique 12 character signature with every 2 characters
separated by a colon(:), that you previously entered to reserve the device's IP address.
9 Enter the Source IP Address of the device that you previously entered into the Static IP Lease List, in the
range of 192.168.1.x In the example above the IP address is: 192.168.20.3
10 Enter a Destination MAC Address if the connection is to a single device. This is useful for VPN connections.
If you wish the destination MAC address to be any address, leave the field blank.
11 Enter a
Destination IP Address if the connection is to a single device. This is useful for VPN connections.
If you wish the destination IP address to be any address, leave the field blank.