8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Configure Switching User Manual201
7. Select the IGMP Snooping Status Enable or Disable radio button.
This selection specifies the administrative mode for IGMP snooping for the switch. The
default is Disable.
8. Select the V
alidate IGMP IP header Enable or Disable radio button.
When IGMP IP header validation is enabled, any IGMP IP header must include the
Router
Alert, ToS, and TTL information. Otherwise, the IGMP packet is discarded. The
default value is Enable.
9. Click the Apply button.
Your settings are saved.
10. T
o refresh the page with the latest information about the switch, click the Update button.
The following table displays information about the global IGMP snooping status and statistics
on the page.
Table 43. IGMP Snooping Configuration information
Field Description
Multicast Control Frame Count The number of multicast control frames that are processed by the switch.
Interfaces Enabled for IGMP
Snooping
The interfaces that are enabled for IGMP snooping.
VLAN IDs Enabled For IGMP
Snooping
The IDs of the VLANs that are enabled for IGMP snooping.
VLAN IDs Enabled For IGMP
Snooping Querier
The IDs of the VLANs that are enabled for IGMP snooping querier.
Configure IGMP snooping for interfaces
To configure IGMP snooping for interfaces:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is of
f-network using an Ethernet cable.
To Next Page
Loading...
Need help?
General