8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Configure Switching User Manual229
Set the dynamic address aging interval
You can set the address aging interval for the forwarding database. This is the time-out
period in seconds for aging out dynamically learned forwarding information.
To set the address aging interval:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the switch on-network and
connected to the Internet on page 19 or Access the switch off-network on page 30.
The login page displays.
If the NETGEAR Business page displays, see Register and access the switch with your
NETGEAR account on page 34.
4. Enter one of the following passwords:
• After registration, enter the local device password.
By default, the local device password is password.
• If you previously managed the switch through the Insight app or Cloud portal, enter
the Insight network password for the last Insight network location.
For information about the credentials, see Credentials for the local browser interface on
page 32.
5. Click the Login button.
The System Information page displays.
6. Select Switching > Address Table > Advanced > Dynamic Addresses.
Interface The interface upon which this address was learned.
Status The status of this entry. The meanings of the values are as follows:
• Static. The value of the corresponding instance was added by the system or a user
and cannot be relearned.
• Learned. The value of the corresponding instance was learned, and is being used.
• Management. The value of the corresponding instance is also the value of an
existing instance of dot1dStaticAddress.
Table 48. MAC address table information (continued)
Field Description
To Next Page
Loading...
Need help?
General