8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Specifications and Default Settings User Manual488
System setup and maintenance settings
The following table describes the system setup and maintenance settings.
Table 83. System setup and maintenance settings
Feature Sets Supported Default
Boot code update 1 N/A
DHCP 1 Enabled
Static IP address 1 192.168.0.239
System name configuration 1 N/A
Configuration save/restore 1 N/A
Firmware upgrade 1 N/A
Restore defaults 1 (local browser interface and
rear-panel button)
N/A
Dual image support 1 Enabled
Factory reset 1 N/A
Port characteristics
The following table describes the port characteristics.
L2 Loop Protection
Admin mode Disabled
Table 84. Port characteristics
Feature Sets Supported Default
Auto negotiating speed and
full/half duplex
All ports Auto negotiation
Auto MDI/MDIX For crossover cables on all ports Enabled
802.3x flow control/back pressure All ports Disabled
Port mirroring: TX, RX, Both 1 Disabled
Table 82. General feature default settings (continued)
Feature Name/Setting Default
To Next Page
Loading...
Need help?
General