8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Maintain or Troubleshoot the Switch User Manual448
If the NETGEAR Business page displays, see Register and access the switch with your
NETGEAR account on page 34.
4. Enter one of the following passwords:
• After registration, enter the local device password.
By default, the local device password is password.
• If you previously managed the switch through the Insight app or Cloud portal, enter
the Insight network password for the last Insight network location.
For information about the credentials, see
Credentials for the local browser interface on
page 32.
5. Click the Login button.
The System Information page displays.
6. Select Maintenance > File Management > Copy.
7. Select the Source Image image1 or image2 radio button to specify the image to be copied.
8. Select the Destination Image image1 or image2 radio button to specify the destination
image.
9. Click the Apply button.
Your settings are saved.
Configure dual image settings
The Dual Image feature allows the switch to retain two images in permanent storage. You
can select which image must be loaded when the reboots, specify an image description, or
delete an image. This feature reduces switch down time when you are upgrading or
downgrading the software image.
Change the software image that loads when the switch starts or reboots
To change the image that loads during the boot process:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is of
f-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser
, enter the IP address of the switch.
To Next Page
Loading...
Need help?
General