8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Specifications and Default Settings User Manual480
Switch default settings
The following table describes the switch default settings.
Table 81. Switch default settings
Feature Default
IP address 192.168.0.239
Subnet mask 255.255.255.0
Default gateway 192.168.0.254
Protocol DHCP
Management VLAN ID 1
IPv6 admin mode Enabled
IPv6 address auto configuration Disabled
DHCPv6 Disabled
Minimum length for the local device
password
Eight characters
SNTP client Enabled
Global logging Enabled
Memory logging Enabled (Severity level: informational and above)
Persistent (flash) logging Disabled
DNS Enabled (No servers configured)
SNMP Traps Enabled
Automatic saving to the startup
configuration
Enabled, but you must click the Apply button to save changes that
you make on a page.
TACACS+ No server configured
RADIUS No server configured
Denial of service protection Disabled
Dot1x authentication (IEEE 802.1X) Disabled
MAC-based port security All ports are unlocked
Access control lists (ACL) None configured
Protected ports None
Advertised port speed Maximum capacity
To Next Page
Loading...
Need help?
General