8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Configure System Information User Manual91
light. Transition to low power mode does not change the link status. Frames in transit are
not dropped or corrupted in transition to and from low power mode. Transition time is
transparent to upper layer protocols and applications.
10. Click the Apply button.
Your settings are saved.
Use the Device View
For information about the device view, see Use the Device View of the local browser
interface on page 40.
Configure Power over Ethernet
For models GS110TPv3 and GS110TPP, you can configure the global Power over Ethernet
(PoE) configuration settings and the PoE settings for each port.
Note: For more information about PoE, see the hardware installation guide,
which you can download by visiting netgear.com/support/download/.
PoE concepts
Models GS110TPv3 and GS110TPP include eight PoE plus (PoE+) ports.
The following table shows the capacity for each model.
Table 19. PoE capacities for models GS110TPv3 and GS110TPP
Model Maximum PoE Power
Per Individual Port
Maximum Power Budget Across
All Active PoE+ Ports
GS110TPv3 30W PoE+ (IEEE 802.3at) 55W
GS110TPP 30W PoE+ (IEEE 802.3at) 120W.
By default, supplied power is prioritized in ascending port order, up to the total power budget
of the device. If the power requirements for the attached devices exceed the total power
budget of the switch, the power to the device on the highest-numbered PoE+ port is disabled
Note: By purchasing and connecting the
NETGEAR optional power adapter model
EPS200W, you can upgrade the PoE
power budget to 190W.
To Next Page
Loading...
Need help?
General