8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Configure Routing User Manual251
controls whether a static route is more or less preferred than other static routes to the
same destination.
8. In the Description field, enter a description for the route.
The description must consist of alphanumeric, hyphen, or underscore characters and can
be up to 31 characters in length.
9. Click the Add button.
The static route is added to the switch.
10. T
o refresh the page with the latest information about the switch, click the Update button.
The following table describes the nonconfigurable data that is displayed.
Table 53. Learned Routes information
Field Description
Network Address The IP route prefix for the destination.
Subnet Mask The portion of the IP interface address that identifies the attached network (also referred
to as the subnet or network mask).
Protocol The protocol that created the specified route. The possibilities are one of the following:
• Local
• Static
Route Type The route type can be Connected, Static, or Dynamic, depending on the protocol.
Next Hop Interface The outgoing router interface to use when forwarding traffic to the destination.
Next Hop Address The outgoing router IP address to use when forwarding traffic to the next router (if any) in
the path toward the destination.
The next router is always one of the adjacent neighbors
or the IP address of the local interface for a directly attached network.
Preference The preference is an integer value from 0 to 255. You can specify the preference value
(sometimes called administrative distance) of an individual static route.
Among routes to
the same destination, the route with the lowest preference value is the route entered into
the forwarding database. By specifying the preference of a static route, you control
whether a static route is more or less preferred than routes from dynamic routing
protocols. The preference also controls whether a static route is more or less preferred
than other static routes to the same destination.
Metric The administrative cost of the path to the destination. If no value is entered, the default
is 1. The range is 0–255.
To Next Page
Loading...
Need help?
General