8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Configure System Information User Manual80
If the NETGEAR Business page displays, see Register and access the switch with your
NETGEAR account on page 34.
4. Enter one of the following passwords:
• After registration, enter the local device password.
By default, the local device password is password.
• If you previously managed the switch through the Insight app or Cloud portal, enter
the Insight network password for the last Insight network location.
For information about the credentials, see
Credentials for the local browser interface on
page 32.
5. Click the Login button.
The System Information page displays.
6. Select System > Management > Denial of Service > Denial of Service Configuration.
7. Select the types of DoS attacks for the switch to monitor and block and configure any
associated values:
• Denial of Service Min TCP Header Size. Specify the minimum
TCP header size
allowed. If you select the Denial of Service TCP Fragment radio button, the switch
drops the first TCP fragment with a TCP payload packet for which the minimum TCP
header size is larger than the IP payload length minus the IP header size. The range
for the minimum TCP header size is from 0 to 31. The default value is 20.
To Next Page
Loading...
Need help?
General