Network and System Management
398
ProSecure Unified Threat Management (UTM) Appliance
Figure 240.
3. Select the Check to Edit Password check box. The password fields become available.
4. Enter the old password, enter the new password, and then confirm the new password.
Note: The ideal password should contain no dictionary words from any
language, and should be a mixture of letters (both uppercase and
lowercase), numbers, and symbols. Your password can be up to
30 characters.
5. As an option, you can change the idle time-out for an administrator login session. Enter a
new number of minutes in the Idle Timeout field. (The default setting is 5 minutes.)
6. Click Apply to save your settings.
7. Repeat step 1 through step 6 for the user with the name guest.
Note: After a factory defaults reset, the password and time-out value are
changed back to password and 5 minutes, respectively.
You can also change the administrator login policies:
• Deny login access from a WAN interface. By default, the administrator can log in from a
WAN interface.
• Deny or allow login access from specific IP addresses. By default, the administrator can
log in from any IP address.
To Next Page
Loading...
