Network and System Management
407
ProSecure Unified Threat Management (UTM) Appliance
Upgrade the Firmware from an Update Server and Reboot the UTM
When the UTM is online, you can let the UTM connect to a remote update server to query new
firmware versions. You can then decide whether or not you want to download new firmware, and
whether or not you want to install new firmware.
Note: Upgrading the UTM firmware from an update server is also referred to
as an online upgrade.
To upgrade the UTM’s firmware directly from an update server and reboot the UTM:
1. In the Firmware Download section of the Firmware screen, click Query to display the
available firmware versions.
2. Select the radio button that corresponds to the firmware version that you want to download
onto the UTM.
3. Click Download. The Download status bar shows the progress of the download. The
following figure shows the Firmware screen after the firmware download is complete.
Figure 245. Firmware screen, after firmware download
4. Click Install Downloaded Firmware.
5. After the firmware installation process is complete, the newly installed firmware is the
secondary firmware and not the active firmware. Ensure that the Activation radio button for
the secondary firmware is selected (it should have been selected automatically).
To Next Page
Loading...
