To Next Page

To Previous Page

xDSL Module for the UTM9S

520

ProSecure Unified Threat Management (UTM) Appliance

Figure 308.

3. Configure the protocol binding settings as explained in the following table:

Table 135. Add Protocol Binding screen settings

Setting Description

Service From the drop-down list, select a service or application to be covered by this rule. If the

service or application does not appear in the list, you need to define it using the Services

screen (see Service-Based Rules on page 123).

Local Gateway From the drop-down list, select the DSL interface or one of the WAN interfaces.

Source Network The source network settings determine which computers on your network are affected by

this rule. Select one of the following options from the drop-down list:

Any All devices on your LAN.

Single address In the Start IP field, enter the IP address to which the rule is applied.

Address Range In the Start IP field and End IP field, enter the IP addresses for the

range to which the rule is applied.

Group 1–Group 8 If this option is selected, the rule is applied to the devices that are

assigned to the selected group.

Note: You can also assign a customized name to a group (see

Change Group Names in the Network Database on page 110).

Destination

Network

The destination network settings determine which Internet locations (based on their IP

address) are covered by the rule. Select one of the following options from the drop-down

list:

Any All Internet IP address.

Single address In the Start IP field, enter the IP address to which the rule is applied.

Address range In the Start IP field and End IP field, enter the IP addresses for the

range to which the rule is applied.

NETGEAR UTM9S Reference Manual

Other manuals for NETGEAR UTM9S