Nokia 7330 - Neighbor; Service Commands; Service; Table 103 Neighbor Command

Monitor Commands
102
"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
3HH-11982-AAAA-TQZZA Issue: 10
5.3.4.8 neighbor
Table 103 neighbor command
5.3.5 Service Commands
5.3.5.1 service
Table 104 service command
Item Description
Syntax neighbor interface [interface...(up to 5 max)] [interval seconds] [repeat repeat] [absolute |
rate]
Context monitor>router>rip
Description This command displays statistical RIP neighbor information at the configured interval until the
configured count is reached.
The first screen displays the current statistics related to the specified neighbor(s). The
subsequent statistical information listed for each interval is displayed as a delta to the previous
display.
When the rate keyword is specified, the “rate per second” for each statistic is displayed instead
of the delta.
Monitor commands are similar to show commands but only statistical information displays.
Monitor commands display the selected statistics according to the configured number of times
at the interval specified.
Parameters neighbor ip-address — Displays damping information for entries received from the BGP
neighbor. Up to 5 IP addresses can be specified.
interval seconds — Configures the interval for each display in seconds.
Default: 10 seconds
Values: 5 — 60
repeat repeat — Configures how many times the command is repeated.
Default: 10
Values: 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
Item Description
Syntax service
Context monitor
(1 of 2)