Nokia 7330 - Ilm; Lspinfo; Table 156 Ilm Command; Table 157 Lspinfo Command

Tools
148
"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
3HH-11982-AAAA-TQZZA Issue: 10
7.2.2.23 ilm
Table 156 ilm command
7.2.2.24 lspinfo
Table 157 lspinfo command
Item Description
Syntax ilm [endpoint endpoint | sender sender | nexthop nexthop |
lsp-id lsp-id| tunnel-id tunnel-id | label start-label end-label]
Context tools>dump>router>mpls
Description This command displays Incoming Label Map (ILM) information for MPLS.
Parameters endpoint endpoint — Specifies the IP address of the last hop.
Value: IP address (a.b.c.d)
sender sender — Specifies the IP address of the sender.
Value: IP address (a.b.c.d)
nexthop nexthop — Specifies the IP address of the next hop.
Value: IP address (a.b.c.d)
lsp-id lsp-id — Specifies the LSP ID.
Values: 0 — 65535
tunnel-id tunnel-id — Specifies the tunnel ID.
Values: 0 — 65535
label start-label end-label — Specifies the label switched path that is signaled for this entry.
Values: start-label: 32 — 131071
end-label: 32 — 131071
Item Description
Syntax lspinfo
Context tools>dump>router>mpls
Description This command displays Label-Switched Path (LSP) information for MPLS.