Nokia 7330 - Measurement-Period; Period; Table 219 Period Command; Table 220 Measurement-Period Command

"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
Ethernet Connection Fault Management
Issue: 10 3HH-11982-AAAA-TQZZA 189
8.12.1.14 period
Table 219 period command
8.12.1.15 measurement-period
Table 220 measurement-period command
Default 7
Parameters priority — <0,1,2…7>
Item Description
(2 of 2)
Item Description
Syntax period period
Context configure>eth-cfm>y1731pm>domain
Description The value of period specifies the time to wait between the transmission of one OAM request
and the next. This parameter can be set only when admin status is set to disabled. The
applicability, range, and default value of this object vary with type, as described below.
The no form of the command reverts the value to the default.
Default two-way-slm — 1
two-way-delay — 1
single-end-loss — 60
Parameters two-way-slm (SLM) — 1...10
two-way-delay (DM) — 1...10
single-end-loss (LM) — 60...300
Item Description
Syntax measurement-period period
Context configure>eth-cfm>y1731pm>domain
(1 of 2)